Lead-free Wave Soldering-Lead-free Wave Soldering Manufacturers, Suppliers and Exporters on vcutpcbdepaneling.com.Soldering Machines-N-Wave soldering

Products categories

Wave soldering

Location: Home -> Hot Products -> products -> SMT wave soldering machine -> Wave soldering -> Lead-free Wave Soldering-Lead-free Wave Soldering Manufacturers, Suppliers and Exporters on vcutpcbdepaneling.com.Soldering Machines-N

[View Origina] [BACK]

Lead-free Wave Soldering-N Series
1. Selective sprayer ( optional )
2. Compatible with customer MES system
3. The spray is far distant from preheating zone.preventing fire hazard
4. Preheating heat pipe is U-typed and its material high temperature resistant stainless steel sintered tube, with a servicelife of more than 12 years
5. modular design of preheating system and insulation measures are good6、1/2HP high power wave motor, maximum peak height up to 16mm.(optional for above 20MM)
6. 1KG/10HLow amount of machine tin dross

N Comparison table of technical parameters of EIP wave soldering series

Dimension (LxWxH)	4550x1605x1715mm	4550x1886x1715mm	4550x1865x1715mm
PCB transport direction	L--->R (R --->L Optional)
Main voltage	3P5W380VAC, 50/60HZ 110A	3P5W380VAC, 50/60HZ 110A	3P5W380VAC, 50/60HZ 115A
Power supply requirements	50KW
Air power requirements	0.3- 0.7MPa
Total power	40KW	40KW	40KW
Normal power consumption	10KW	10KW	10KW
Control method	PC+PLC
Preheating method	Hot air / infrared / spotlight optional
Preheating fan speed control mode	Promise frequency control
Number of preheating zones	3
Pre-heat zone length	1740mm
Pre-heat temperature	Room temperature - 280°C
Pre-heat temperature control	PID+SSR mode
wave running mode	Mechanical pump
Tin furnace heat pipe power	1.0KW*12
Tin furnace capacity itin specific gravity 7.5	650KG	750KG	800KG
Tin furnace limit withstand temperature	MAX: 300°C
Tin furnace limit the use of temperature	MAX: 280'C
Tin furnace control mode	PID+SSRmode
Peak drive power	1/2HPx23P 220VAC	1/2HP+1HP 3P 220VAC	1/2HPx1 1HPx1 3P 220VAC
Crest height adjustmant method	Frequency conversion regulation
Tin furnace heating time	150MIN Set temperature 250°C		180MIN Set temperature 260°C
PCB transfer speed	0- 1800mm / min
PCB board width range	80-350mm	80-510mm	80-610mm
PCB board height	Top: 110mm Bottom: 25mm
PCB inlet transport height	750±20mm
Transport guide inclination	40 70 Range adjustment		4°-7°
Transport motor power	90W 3P 220VAC
Transport motor speed control mode	Frequency control
Nitrogen consumption	15m / h100ppm
Nitrogen gas source pressure	0.5-0.8MPA
Nitrogen gas source oxygen content	10PPM
Number of nitrogen flow meters	3
Flux flow	10-100ml/MIN
Spray pressure	0.25MP A-0.5MPA
Exhaust fan	380VAC 750W
Suction pipe diameter	Cll200mm

Welcome message, we will reply within 24 hours!
Name：
E-mail：
Phone：
Comment：